This is images I took after I put in the ADXL 202 accelerometer in my Pilot 1000. I found how to do it on the following web page http://bodotill.suburbia.com.au/adxl202/adxl202.html
|
|
|
| Overview of the backside of the circuit board with the accelerometer at the top-left corner of the processor. | A close-up on the accelerometer with the external components connected with thin wires. |
 |
 |
 |
| Thin wires were used to connect the external components. | As this was a Pilot 1000 I could not really follow the instructions on the web page. This is where I took the ground. |
 |
 |
| The connections to the CPU. It was quite hard to solder the wires to the legs of the CPU. | I glued the wires with plastic melt glue so they would not fall of. The glue is the silver orb at the top of the image. |
Last updated 2000-11-15 by Karl-Petter Åkesson